AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |
Back to Blog
Arduino Dmx Fade4/6/2021
This is a do-it-yourself construction manual for a simple USB interface to control a DMX512 lighting bus.The PCB layout is optimized for straightforward reproduction on a Veroboard.
Arduino Dmx Fade Manual For AAn Arduino Leonardo can be completed with a DMX transmitter even more simply (see below). Due to the limited SRAM size of the ATmega32U4 microcontroller (the soft fade feature needs a lot), the number of accessible DMX channels is max.256. Because this firmware makes use of the ATmega Boot Section, it can only be programmed with an external ISP programmer, not with a bootloader. Three different command sets are selectable by a jumper or switch. The microcontroller is configured as USB Communication Device (CDCACM class) and is seen as a virtual COM port by the host. Formally this is implemented here as ASCII command Z (hex 5A). So when it gets received, the microcontroller jumps into the corresponding decoder routine and returns back to the ASCII command mode after the MiniDMX packet is processed. Fade processes, prestored lighting scenes and the chaser are not supported by the MiniDMX protocol. Arduino Dmx Fade Free Software DMXControl3But it is compatible with the free software DMXControl3 (used for test here) and Freestyler. Unfortunately the original website with the MiniDMX specification is not online anymore. This way DMX is controlled easily by a MIDI sequencer or other musicians tools. The ASCII command set (more features but 256 channels) is the same as described above and selectable by a jumper or switch. In both positions, the microcontroller is configured as USB Communication Device (CDCACM class) and is seen as a virtual COM port by the host. When it is removed, USB starts as virtual MIDI interface with the MIDI command set (or 512 channels MiniDMX, depending on the installed firmware version). The grey wire sends DMX from Arduino TX (D1), the violet wire (D2) disables the DMX transmitter during USB enumeration. Connections are made with 2.54mm pinheads, nothing is soldered at the Arduino. Hex code for Arduino Micro and Leonardo (version 1.11, 08 January 2017) recommended Fuses configuration: extended 0xF9, high 0xCF, low 0xFF). Hex code for Arduino Micro and Leonardo. Both firmware versions work unmodified with Arduino Leonardo, but in default state get recognized as Arduino Micro. The LED of the Micro version is doubled at the Leonardo onboard TX led with the difference that is off during idle state and goes on when data are transferred. This description is for information only, without any warranty. Trademarks and product names cited in this text are property of their respective owners.
0 Comments
Read More
Leave a Reply. |